In July 2018, the Government of India imposed a two-year safeguard duty on solar cells and modules imported from China, Malaysia and Taiwan. In an attempt to spur domestic manufacturing, a 25% duty will be levied for a year, starting from July 2018. The duty rates will decline to 20% for six months starting July 2019, before further being reduced to 15% for another six months. The move has stated two objectives: enhanced energy security through a robust domestic solar manufacturing sector; and increased job creation in the clean energy sector.

At present, India has cell and module manufacturing capacity of 3.1 and 8.8 GW per annum respectively (Table 1). A sizeable proportion of this is located in Special Economic Zones. The Indian manufacturers situated in the SEZ will also be subject to the duty, reducing their competitiveness further. However, while the sales of modules cleared from SEZ to DTA are subject to safeguard duty, the duty is applicable only on the value of imported inputs and not on the value addition done inside the SEZ. Cells manufactured in SEZs and then sold inside the DTA are exempt from safeguard duty (since imported wafers – the raw materials for cell manufacturing – are not subject to safeguard duties). However, standalone module manufacturers located in the domestic tariff area (DTA) will also face increased costs as a result of the safeguard duty as they often import cells for their modules. Only cells manufactured in the DTA (1164 MW) could clearly benefit from the Safeguard Duty.

Table 1: Distribution of Indian PV manufacturing facilities (in MW) by location

Type of Module facility

SEZ

DTA

Cell Manufacturing

2,000

1164

Module Manufacturing

3,825

Source: Directorate General of Trade Remedies, Ministry of Commerce

The relatively underdeveloped state of Indian PV manufacturing can be attributed to the competitive disadvantages of PV manufacturing in India vis-à-vis foreign competitors, particularly Chinese manufacturers. China accounts for close 88% of India’s PV imports and is the dominant force in global PV manufacturing. Upon assessment, the policy support received by Chinese solar PV manufacturers is in stark contrast to the conditions faced by manufacturers in India. Even as the safeguard duty aims to correct for this disparity, it alone will do little for the domestic manufacturing industry. This is better understood in light of the decline in solar deployment targets in China, creating a supply glut in the PV manufacturing market. This has caused the prices of solar cells, wafers, and modules from China falling further. As per estimates from active industry players in India, the prices of imported modules have crashed to as low as USD 0.21/watt. Thus, in the current market, the price of imported modules with the safeguard duty is competitive, or lower, than domestically manufactured modules.

Further, the revision of commissioning timelines for solar projects in India, from 13 – 15 months, to 21 – 24 months allows developers to delay procurement of modules, and pay lower safeguard duties or bypass the duty all together (Figure 1). Thus, even as the competitive edge of the safeguard duty to support domestic manufacturing is limited, it does create significant adverse effects. This is due to uncertainty it has created in the market, marring investor confidence and industry appetite significantly. The safeguard duty will dampen the pace of decline of solar tariffs, and increase the administrative burden of the regulators as they adjudicate pass-through of the cost of the duty as per the Change-in-law clause in the power purchase agreement to the discoms.

Figure 1: Module procurement during safeguard duty period is concentrated in low duty periods

Source - CEEW Analysis

Trade protection measures have historically not been effective means of reviving domestic solar PV manufacturing globally. With benefits spanning fiscal support schemes, access to affordable capital, integrated value chains, and affordable input variable costs, available to the Chinese industry, a declining short-term safeguard duty will not be adequate to balance the scales. Systemic interventions, based on an understanding of global supply chains and PV factory economics, will be necessary to address the competitive disadvantage of the Indian PV manufacturing industry. Measures such as capital subsidy, domestic procurement, investment in R&D of frontier technology, interest rate subvention, and provision of concessional electricity are some steps that could help the resurgence and growth of the domestic PV industry.

The imposition of the safeguard duty has resulted in additional flows into the Indian exchequer. The duty amount collected, INR 1530 crore for the period of August to December 2018, could be used to implement a combination of the proposed market making incentives to strategically advance the domestic solar PV manufacturing market, without creating uncertainty for solar developers, or setting back the tariff advances made by the solar sector.


5 People Liked
Author's Name
Arjun Dutt
Senior Programme Lead
For queries reach out to author
Posted On
16 July 2019
Tags
Solar
Custom Duty
ALMM
Solar Manufacturing
Energy Transition
Share
PUBLICATIONS
Renewable Energy
+ 1 More
July 2019
2 mins read
Arjun Dutt
CEF EXPLAINS
Renewable Energy
+ 1 More
June 2019
2 mins read
Nikhil Sharma
CEF ANALYSIS
Instruments & Regulations
+ 1 More
June 2019
1 mins read
Sugandha Somani
CEF ANALYSIS
Others
April 2023
1 mins read
Amlan Bibhudatta
CEF ANALYSIS
Industrial Decarbonisation
+ 1 More
June 2022
5 mins read
Nikhil Sharma
CEF ANALYSIS
Industrial Decarbonisation
+ 1 More
February 2022
7 mins read
Harsha V Rao
CEF ANALYSIS
Instruments & Regulations
+ 1 More
March 2020
4 mins read
Nikhil Sharma
CEF ANALYSIS
Others
+ 1 More
October 2021
2 mins read
Saloni Jain
CEF ANALYSIS
Electric Mobility
December 2020
7 mins read
Meghna Nair